About Us

Knowledge Center


Terms of Use

Featured Products

Site Map


Contact Us

Motorized XYZ-axis Linear Positioning Stages

Home > Assorted Motorized Multi-axis Actuators

This motorized positioning table is made of aluminum alloy with an elegant black anodized surface.

The drive mechanism is high precision crossed roller.

The knob mounted on the motors allow for manual adjustment. These knobs may be replaced with an optical encoders for precision position verification.

This stage is compatible with OES' line of
Motion Controllers..


Structure Description

Range of Travel (mm) Pitch of Lead Screw
15 1 mm per turn
30 1 mm per turn
50 1 mm per turn
75 1 mm per turn
100 4 mm per turn
150 4 mm per turn
200 4 mm per turn
300 4 mm per turn
400 4 mm per turn
500 4 mm per turn
600 4 mm per turn
700 4 mm per turn
800 4 mm per turn
900 4 mm per turn
1000 4 mm per turn
Travel Guide

High Precision Crossed Roller

Phase Resistance 3.8 Ohm, Bi-directional
Maximum Phase Current 1 Amp
9 pin DB-9 Male Connector
Pin Assignment and Description
1 +5 VDC for the Limit Sensors
2 Positive Limit Switch, Open Collector, Normally Open, Needs Pull up Resistor (1000 OHM)
3 Negative Limit Switch, Open Collector, Normally Open, Needs Pull up Resistor (1000 OHM)
4 Return for+5 VDC
5 Not Connected
6 Phase A+
7 Phase A-
8 Phase B+
9 Phase B-
Main Material Aluminum Alloy
Surface Treatment Black Anodized

Typical Accuracy

Maximum Speed 5 mm / sec
Repeatability 3 μ
Positional Accuracy 10 μ

Accessories Description

Optional Optical Encoders
Optional Servo Motors
Optional Built-in Stepper Motor Drivers
Other Sizes and Strokes Available

Ordering Information

Part No. Description Amount
XYZ-xxx-yyy-zzz-cc Three-axis XYZ-axis Stage Click to Get a Quote



Sharing link:


Home | Products | Accessories | Knowledge Center | About Us | Terms of Use |Testimonials | Featured Products |Site Map | Videos | Contact Us